ENGEE280

Electronics Design

This course is an introduction to the design process in electronic engineering. The use of Computer Aided Design (CAD) as a tool is reinforced using practical exercises.

ENGEE280 - 18B (HAM)

15.0 Points

This course is an introduction to the design process in electronic engineering. The use of Computer Aided Design (CAD) as a tool is reinforced using practical exercises.

Prerequisite(s): ENGEN111 or ENEL111

Restriction(s): ENGG282

Internal assessment/examination ratio: 1:1

Note: There is a compulsory laboratory component.

Timetabled Lectures

The Timetable for 2018 is not available.

Indicative Fees

Fees for 2018 are not yet available.

Paper Outlines

Paper outlines are currently not available for this paper. Please contact the Faculty or School office for further details.

Available Subjects:  Electronic Engineering | Electronics | Engineering

Paper details current as of : 13 September 2017 5:00pm
Indicative fees current as of : 20 September 2017 4:30am

This page has been reformatted for printing.